User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN Setting Example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of IGS-4215 Series
111
4.3.10.2 SFP Module Detail Status
The SFP Module Detail Status screen in Figure 4-3-22 appears.
Figure 4-3-22: SFP Module Detail Status Page Screenshot with Sample Switch
The page includes the following fields:
Object Description
• Port
The logical port for the settings contained in the same row.
• Temperature
Displays the current SFP temperature.
• Voltage
Displays the current SFP voltage.
• Current
Displays the current SFP current.
• Output Power
Displays the current SFP output power.
• Input Power
Displays the current SFP input power.
• Transmit Fault
Displays the current SFP transmits fault.
• Loss of Signal
Displays the current SFP loss of signal.
• Rate Ready
Displays the current SFP rate ready.