User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.2.1 System Information
- 4.2.2 IP Configurations
- 4.2.3 IPv6 Configuration
- 4.2.4 User Configuration
- 4.2.5 Time Settings
- 4.2.6 Log Management
- 4.2.7 SNMP Management
- 4.2.8 RMON
- 4.2.9 Fault Alarm Configuration
- 4.2.10 Remote Management
- 4.3 Port Management
- 4.3.1 Port Configuration
- 4.3.2 Port Counters
- 4.3.3 Bandwidth Utilization
- 4.3.4 Port Mirroring
- 4.3.5 Jumbo Frame
- 4.3.6 Port Error Disabled Configuration
- 4.3.7 Port Error Disabled Status
- 4.3.8 Protected Ports
- 4.3.9 EEE
- 4.3.10 SFP Module Information
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN Setting Example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 IGMP Snooping
- 4.9 MLD Snooping
- 4.10 LLDP
- 4.11 MAC Address Table
- 4.12 Quality of Service
- 4.13 Security
- 4.14 Ring
- 4.15 Maintenance
- 4.16 Diagnostics
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of IGS-4215 series
49
4.1.2.1 Saving Configuration via the Web
In the Industrial Managed Switch, the running configuration file stores in the RAM. In the current version, the running
configuration sequence of running-config can be saved from the RAM to FLASH by ”Save Configuration” function, so that the
running configuration sequence becomes the startup configuration file, which is called configuration save.
To save all applied changes and set the current configuration as a startup configuration, the startup-configuration file will be
loaded automatically across a system reboot.
1. Click “Save > Save Configuration” to log in to the “Configuration Manager” page.
2. Press the “Apply” button to save running configuration to start up configuration.