User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.2.1 System Information
- 4.2.2 IP Configurations
- 4.2.3 IPv6 Configuration
- 4.2.4 User Configuration
- 4.2.5 Time Settings
- 4.2.6 Log Management
- 4.2.7 SNMP Management
- 4.2.8 RMON
- 4.2.9 Fault Alarm Configuration
- 4.2.10 Remote Management
- 4.3 Port Management
- 4.3.1 Port Configuration
- 4.3.2 Port Counters
- 4.3.3 Bandwidth Utilization
- 4.3.4 Port Mirroring
- 4.3.5 Jumbo Frame
- 4.3.6 Port Error Disabled Configuration
- 4.3.7 Port Error Disabled Status
- 4.3.8 Protected Ports
- 4.3.9 EEE
- 4.3.10 SFP Module Information
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN Setting Example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 IGMP Snooping
- 4.9 MLD Snooping
- 4.10 LLDP
- 4.11 MAC Address Table
- 4.12 Quality of Service
- 4.13 Security
- 4.14 Ring
- 4.15 Maintenance
- 4.16 Diagnostics
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of IGS-4215 series
239
The page includes the following fields:
Object Description
• Queue ID
Displays the current queue ID.
• Rate Limit (Kbps)
Displays the current rate limit.
4.12.5 Storm Control
Storm control for the switch is configured on this page.
There is an unknown unicast storm rate control, unknown multicast storm rate control, and a broadcast storm rate control.
These only affect flooded frames, i.e. frames with a (VLAN ID, DMAC) pair not present on the MAC Address table.
4.12.5.1 Global Setting
The Storm Control Global Setting and Information screens in Figure 4-12-23 and Figure 4-12-24 appear.
Figure 4-12-23: Storm Control Global Setting Page Screenshot
The page includes the following fields:
Object Description
• Unit
Controls the unit of measure for the storm control rate as "pps" or "bps". The
default value is "bps".
• Preamble & IFG
Set the excluded or included interframe gap.
Buttons
: Click to apply changes.
Figure 4-12-24: Storm Control Global Information Page Screenshot