User Manual

8
2.4 Switch Upper Panel
The upper panel of the Industrial Gigabit Ethernet Switch
consists of one terminal block connector within two DC power
inputs,
Figure 2-2 shows the upper panel of the Industrial Gigabit
Ethernet Switch.
Input
DC12~48V, AC 24V
V1+ V1- V2+ V2-
PWR1
PWR2Fault
1 2 3 4 5 6
Figure 2-2: Industrial Gigabit Ethernet Switch Upper Panel
2.5 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of
Industrial Gigabit Ethernet Switch is used for two DC redundant
power inputs. Please follow the steps below to insert the power
wire.
When performing any of the procedures like
inserting the wires or tightening the wire-clamp
screws, make sure the power is OFF to prevent
from getting an electric shock.