User Manual
18
2.Check whether the ber-optic cable type matches with the
SFP transceiver requirement.
To connect to 1000BASE-SX SFP transceiver, please use
the multi-mode ber cable with one side being the male
duplex LC connector type.
To connect to 1000BASE-LX or 1000BASE-BX SFP trans-
ceiver, please use the single-mode ber cable with one
side being the male duplex LC connector type.
Connect the Fiber Cable
1. Insert the duplex LC connector into the SFP transceiver.
2. Connect the other end of the cable to a device with SFP
transceiver installed.
3. Check the LNK/ACT LED of the SFP slot on the front of the
Industrial Gigabit Ethernet Switch. Ensure that the SFP trans-
ceiver is operating correctly.
4. Check the Link mode of the SFP port if the link fails.
Note
It is recommended to use PLANET SFPs on the
Industrial Gigabit Ethernet Switch. If you insert an
SFP transceiver that is not supported, the Indus-
trial Gigabit Ethernet Switch will not recognize it.