User Manual

Step 5: Lightly pull out the bottom of the switch for removing

it from the track.

3.2 Wall-mount Plate Mounting

To install the Industrial Gigabit Ethernet Switch on the wall,

please follow the instructions described below.

Step 1: To remove the DIN-Rail from the Industrial Gigabit

Ethernet Switch, loosen the screws to remove the

DIN-rail.

Step 2: Place the wallmount plate on the rear panel of the

Industrial Gigabit Ethernet Switch.

Step 3: Use the screws to screw the wallmount plate on the

Industrial Gigabit Ethernet Switch.

Step 4: Use the hook holes at the corners of the wallmount

plate to hang the Industrial Gigabit Ethernet Switch on

the wall.

Step 5: To remove the wallmount plate, reverse the steps

above.