User Manual

14
3. Installation
This section describes the functionalities of the Industrial
Gigabit Ethernet Switch’s components and guides how to install
it on the DIN-rail and wall. Basic knowledge of networking is
assumed. Please read this chapter completely before continuing.
Note
This following picture is telling the user how
to install the device, and the device is not IGS-
1020TF.
3.1 DIN-rail Mounting Installation
The DIN-rail is screwed on the Industrial Gigabit Ethernet Switch
when out of factory. When replacing the wall-mount application
with DIN-rail application, Industrial Gigabit Ethernet Switch
is needed. Please refer to the following gures to screw the
DIN-rail on the Industrial Gigabit Ethernet Switch. To hang the
Industrial Gigabit Ethernet Switch, follow the following steps:
Step 1: Screw the DIN-rail on the Industrial Gigabit Ethernet
Switch.