Datasheet

IGS-10020HPT
10
Specications
Product
IGS-10020HPT
Hardware Specications
Version 3
Copper Ports 8 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports
Reset Button
< 5 sec: System reboot
> 5 sec: Factory default
Enclosure IP30 aluminum case
Installation DIN-rail kit and wall-mount kit
Connector
Removable 6-pin terminal block for power input
Pin 1/2 for Power 1, Pin 3/4 for fault alarm, Pin 5/6 for Power 2
Removable 6-pin terminal block for DI/DO interface
Pin 1/2 for DI 1 & 2, Pin 3/4 for DO 1 & 2, Pin 5/6 for GND
Alarm One relay output for power failure. Alarm Relay current carry ability: 1A @ DC 24V
DI/DO
2 Digital Input (DI): Level 0: -24V~2.1V (±0.1V)
Level 1: 2.1V~24V (±0.1V)
Input Load to 24V DC, 10mA max.
2 Digital Output (DO): Open collector to 24V DC, 100mA max.
Dimensions (W x D x H) 72 x 107x 152 mm
Weight 1096g
Power Requirements DC 12-48V
Power Consumption 257 watts/876BTU (Full loading with PoE function)
ESD Protection 6KV DC
EFT Protection 6KV DC
LED Indicator
System:
Power 1 (Green)
Power 2 (Green)
Fault Alarm (Green)
Ring (Green)
R.O. (Ring Owner) (Green)
Per10/100/1000TRJ45Ports:
PoE-in-Use (Orange)
LNK/ACT (Green)
Per100/1000/2500BASE-XSFPInterface:
LNK/ACT (Green)
1G/2.5G (Orange)
Switching Specication
Switch Architecture Store-and-Forward
Switch Fabric 20Gbps/non-blocking
Throughput (packet per second) 14.8Mpps@ 64Bytes packet
Address Table 8K entries, automatic source address learning and aging
Shared Data Buffer 4Mbits
Flow Control
IEEE 802.3x pause frame for full-duplex
Back pressure for half-duplex
Jumbo Frame 9Kbytes
Power Over Ethernet
PoE Standard IEEE 802.3at Power over Ethernet Plus/PSE
PoE Power Supply Type End-span
PoE Power Output
Per port 52V DC, 350mA; max. 15.4 watts (IEEE 802.3af)
Per port 52V DC, 590mA; max. 36 watts (IEEE 802.3at)
Power Pin Assignment 1/2(+), 3/6(-)
PoE Power Budget
60W maximum (DC 12V power input)
120W maximum (DC 24V power input)
240W maximum (DC 48V power input)
Max. Number of Class 2 PDs @ 7 watts 8
Max. Number of Class 3 PDs @ 15.4 watts 8
Max. Number of Class 4 PDs @ 30.8 watts 8
PoE Extend Mode Remote power feeding up to 100m in standard mode and 200m in extend mode
Layer 2 Function
Port Conguration
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Port Status Display each port’s speed duplex mode, link status, ow control status, auto negotiation status, trunk status