User's Manual
16
Note
1. The wire gauge for the terminal block should
be in the range of 12 to 24 AWG.
2. Alarm relay circuit accepts up to 30V, max. 3A
currents.
2.2 Mounting Installation
This section describes how to install the Industrial Media
Converter and make connections to it. Please read the following
steps to perform the procedures in the order being presented.
Note
In the installation steps below, this Manual uses
the IGS-801 (PLANET 8-port Industrial Gigabit
Switch) as an example. However, the steps for
PLANET Industrial Media Converter are similar.