User's Manual

12
Switch Throughput@64 bytes 4.1Mpps @64 bytes
MAC Address Table 16K entries
SharedDataBuer 4Mb SRAM
Flow Control
IEEE 802.3x pause frame for full duplex.
Back pressure for half duplex
Jumbo Frame 10 Kbytes
DIP Switch (Port 1 to Port 8)
Standard mode: 30-watt PoE transmission distance
of 100m at speed of 10/100Mbps
Extend mode: 30-watt PoE transmission distance
of 250m at speed of 10Mbps
LED
3 x LED for System and Power:
 Green: DC Power 1
 Green: DC Power 2
 Red: Power Fault Alarm
2 x LED for PoE Copper Port (Port-1~Port-8):
 Green: LNK/ACT (10/100Mbps)
 Orange: PoE-In-Use
2 x LED for 10/100/1000T Copper Port
(Port-9~Port-10):
 Green: LNK/ACT
 Orange: 1000
2 x LED for per mini-GBIC interface
(Port-9~Port-10)
 Green: LNK/ACT
 Orange: 1000
Connector
Removable 6-pin terminal block
 Pin 1/2 for Power 1
 Pin 3/4 for power fault alarm
 Pin 5/6 for Power 2
Alarm
One relay output for power failure.
Alarm relay current carry ability: 1A @ 24V AC
Power Requirements
48~56V DC, 5.5A (max.)
(>51V DC for PoE+ output recommended)
Power Consumption/
Dissipation
19 watts, 64BTU (Standby without PoE function)
at DC 56V power input
23 watts, 78BTU (Full loading without PoE
function) at DC 56V power input
244 watts, 832BTU (Full loading with PoE function)
at DC 56V power input