ICS-Series User Manual

User’s Manual of ICS-11x Serial Device Server Series
45
4.5.1 Serial setup
The serial setup screen is shown in Figure 4-5-2.
Figure 4-5-2: Serial Setup Page Screenshot
Object Description
• Description
Used to distinguish the name of each serial port. It allows 1 to 15 characters (e.g. A-Z,
a-z, 0-9)
• Baud Rate
The rate of data transmission to and from the attached serial device. It allows 50 bps to
921600 bps. The default is 921600 bps.
• Stop Bits
The stop bit follows the data and parity bits in serial communication. It indicates the end
of transmission. The default is 1.
• Data Bits
Indicates the number of the bits in a transmitted data package. The allowed value is
5,6,7,8 and default value is 8.
• Parity
This parameter controls the error checking mode. It support five modes and default
value is none.
 Even
 Odd
 None
 Space
 Mark
• Interface
The device server supports three interfaces. The default value is RS-232.
 RS-232
 RS-422
 RS-485 2-Wire
 RS-485 4-Wire
• Flow Control
The method is used to suspend and resume data transmission to ensure that data is not
lost. It supports four methods and default value is none.
 None
 RTS/CTS
 Xon/Xoff
 DTR/DSR