ICS-Series User Manual

User’s Manual of ICS-11x Serial Device Server Series
19
 Reset button
On the rear panel, the reset button is designed for rebooting the system. The following is the summary table of the reset
button functions:
Reset Button Reset Button Pressed and Released Function
System Reset
< 5 sec: System reboot Reboot the Serial Server
> 5 sec: Factory default
Reset the Serial Server to Factory
Default
configuration. The Serial Server will then
reboot and load the default settings as
shown below:
。 Default Username: admin
。 Default Password: admin
。 Default IP address: 192.168.0.100
。 Subnet mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
2.1.5 Power Information:
The central pole of the Serial Server’s power jacks measures 2.5mm wide that require +5VDC power input. It conforms to the
bundled AC-DC adapter and PLANET’s media chassis. Should you have the issue of power connection, please contact your
local sales representative.
Please keep the AC-DC adapter as a spare part when the Serial Server is installed in a media chassis.(ICS-110/115A)
2.5mm
Width of DC Receptacle: 2.5mm
+5V for each slot
DC receptacle is 2.5mm wide that matches the central pole; the width of the Serial Server
DC jack also measures 2.5mm.
Warning: Do not install any improper unit.
The device is a power-required device, meaning it will not work till it is powered. If your networks should be active all the time,
please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data loss or network
downtime.
In some areas, installing a surge suppression device may also help to protect your Serial Servers from being damaged by
unregulated surge or current to the converter or the power adapter.