Media Converter User's Manual

User’s Manual of ICS-10x
-39-
Setup Operation Mode and Serial Port of ICS-10x
1. Set the ICS-10X mode to “Telnet server mode” from web interface.
2. Set the Serial Port Configuration of ICS-10x as below:
Mode:
RS-232
Baudrare:
9600
Character Bits:
8
Parity Type :
none
Stop Bit :
1
Hardware Flow Control:
none
Execute “Telnet” command from Windows Start Menu
3. Click the Start Menu and go to Run
4. Type "telnet" without the quotes, and hit enter.
Figure 4-40 Example Windows Excuse - Telnet
5. While the Telnet window appears, type “open xxx,xxx,xxx,xxx”, xxx is the IP address of the ICS-10x Telnet Server.
In this case we type “open 192.168.0.100” and press enter.
Figure 4-41 Example Windows Excuse - Telnet
6. Then can use the telnet connection to configure the switch just like console direct connect to the COM port of the
switch.