ICG-2515(W)-NR User Manual

Industrial 5G NR Cellular Gateway
ICG-2515-NR series
- 37 -
Chapter 4. Web-based Management
This chapter provides setup details of the device’s Web-based Interface.
4.1 Introduction
The device can be configured with your Web browser. Before configuring, please make sure your PC is
under the same IP segment with the device.
4.2 Logging in to the Cellular Gateway
Refer to the steps below to configure the cellular gateway:
Step 1. Connect the IT administrator’s PC and cellular gateways LAN port (port 1) to the same hub /
switch, and then launch a browser to link the management interface address which is set to
http://192.168.1.1 by default.
The DHCP server of the cellular gateway is enabled. Therefore, the LAN
PC will get IP from the VPN cellular gateway If user needs to set IP
address of LAN PC manually, please set the IP address within the range
between 192.168.1.2 and 192.168.1.254 inclusively, and assigned the
subnet mask of 255.255.255.0.
Step 2. The browser prompts you for the login credentials. (Both are “admin” by default.)
Default IP address: 192.168.1.1
Default user name: admin
Default password: admin
Default SSID (2.4G): PLANET_2.4G (ICG-2515W-NR only)
Default SSID (5G): PLANET_5G (ICG-2515W-NR only)
Administrators are strongly suggested to change the default admin and
password to ensure system security.