ICG-2510W(G)-LTE Series User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. CELLULAR GATEWAY MANAGEMENT
- 4. WEB CONFIGURATION
- 5. APPENDIX A RJ45 Pin Assignments
49
Bridging-Create
Bridge
Creates a new empty network bridge for later use. STP means
Spanning Tree Protocol and with PRIO users are able to set the bridge
priority order. The lowest number has the highest priority.
Bridging-Assign
to Bridge
Allows users to assign any valid interface to a network bridge. Consider
setting the Wireless Interface options to Bridged if they want to assign
any Wireless Interface here. Any system specific bridge setting can be
overridden here in this field.
Current Bridging
Table
Shows current bridging table
Create Bridge
Click 'Add' to create a new bridge; configuration is shown below:
Create bridge option: the first br0 means bridge name. STP means to on/off spanning tree protocol. Prio means priority
level of STP; the smaller the number, the higher the level. MTU means maximum transfer unit; default is 1500. Delete if
it is not needed. And then click 'Save' or 'Add'. Bridge properties are shown below:
Enter relevant bridge IP address and subnet mask, and then click 'Add' to create a bridge.
Only creating a bridge can be applied.
Assign to Bridge
Assign to Bridge option: To assign different ports to created bridge. For example: assign port (wireless port) is ra0 in
br1 bridge as shown below: