User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- 2.1 Physical Descriptions
- 2.2 Hardware Installation
- 2.3 Initial Utility Installation
- 2.4 Using UPnP of Windows XP or 7
- 2.5 Setting Up ActiveX for the Camera
- Chapter 3. Web-based Management
- Appendix A. The Dimensional Diagram of the Stand
- Appendix B. The Dimensional Diagram of the Camera
- Appendix C. Ping IP Address
- Appendix D. Configuring Port Forwarding Manually
- Appendix E. Waterproofing the Cable Connections
- Appendix F. Joystick Compatibility
- Appendix G. Connecting Audio Devices
- Appendix H. Connecting Digital Input/ Digital Output Devices
- Appendix I. How to Replace the Fuse
- Appendix J. Troubleshooting & Frequently Asked Questions
2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
93
3.10.3.2 Day/Night
The Day/Night section allows user to control the switching between day mode and night
mode. This section will be displayed only for day/night models.
Parameters
Description
Day/Night mode
There are three modes:
Auto: The camera will automatically switch between day mode
(color) and night mode (black/white) under certain exposure level,
defined by user at “Switch from Day mode to Night mode”.
Day: The camera always stays in day mode (color) regardless of
exposure level.
Night: The camera always stays in night mode (black/white)
regardless of exposure level.
Switch from Day
mode to Night mode
The scale of 0~100 allows user define the exposure level at which
the day to night switch should happen. The higher is the value, the
darker the environment has to be to trigger the day to night switch.
3.10.3.3 Image
The Image section allows user to control certain parameters of a video frame.