User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- 2.1 Physical Descriptions
- 2.2 Hardware Installation
- 2.3 Initial Utility Installation
- 2.4 Using UPnP of Windows XP or 7
- 2.5 Setting Up ActiveX for the Camera
- Chapter 3. Web-based Management
- Appendix A. The Dimensional Diagram of the Stand
- Appendix B. The Dimensional Diagram of the Camera
- Appendix C. Ping IP Address
- Appendix D. Configuring Port Forwarding Manually
- Appendix E. Waterproofing the Cable Connections
- Appendix F. Joystick Compatibility
- Appendix G. Connecting Audio Devices
- Appendix H. Connecting Digital Input/ Digital Output Devices
- Appendix I. How to Replace the Fuse
- Appendix J. Troubleshooting & Frequently Asked Questions
2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
82
It is necessary to have the camera’s Line Frequency adjusted according to the
power frequency of the light source to avoid flickering effect.
The natural light source (sun light) is a seamless flow of light – the Line Frequency
setting does not matter for the cameras that are only exposed to natural light.
High Frame Mode allows users to select the resolution with 60fps frame rate, where
some video settings such as Exposure and White Balance, etc. will be automatically
configured. This configuration will be set as the video stream 1 and the original
configuration of stream 1 will now be video stream 2 and so on.
When any of the settings on this page have been modified, click the Apply button and
reboot to make the changes effective.
3.10.2 Compression
The Compression section allows the user to define the compression settings of the video
streams 1, 2, and 3. The purpose of compression is to reduce the bandwidth and VMS
storage consumption.
Usually the stream 1 is configured to be the best quality stream for NVR recording purposes
while the stream 2 and 3 are configured to be with the basic quality for the live view of NVR
or mobile device, to minimize the computing power of NVR used for video decoding.