User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- 2.1 Physical Descriptions
- 2.2 Hardware Installation
- 2.3 Initial Utility Installation
- 2.4 Using UPnP of Windows XP or 7
- 2.5 Setting Up ActiveX for the Camera
- Chapter 3. Web-based Management
- Appendix A. The Dimensional Diagram of the Stand
- Appendix B. The Dimensional Diagram of the Camera
- Appendix C. Ping IP Address
- Appendix D. Configuring Port Forwarding Manually
- Appendix E. Waterproofing the Cable Connections
- Appendix F. Joystick Compatibility
- Appendix G. Connecting Audio Devices
- Appendix H. Connecting Digital Input/ Digital Output Devices
- Appendix I. How to Replace the Fuse
- Appendix J. Troubleshooting & Frequently Asked Questions
2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
76
Host Name is used to identify the camera by a DHCP server. In some networks with very
strict security policy, it is required that all the network devices should have their host name,
and when the devices attempt to access the network by requesting an IP address from a
DHCP server, the DHCP server would check if the host name is among the allowed devices.
On this page, it is possible to edit the Host Name and enable or disable the use of host
name.
Most installation projects include clear network topology and static IP addresses for each
camera. In such cases, you can change the camera to Static IP Address mode and modify
the IP Address, Subnet Mask and Gateway accordingly.
In some rare cases, the camera may be connected to the control center over Internet.