User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- 2.1 Physical Descriptions
- 2.2 Hardware Installation
- 2.3 Initial Utility Installation
- 2.4 Using UPnP of Windows XP or 7
- 2.5 Setting Up ActiveX for the Camera
- Chapter 3. Web-based Management
- Appendix A. The Dimensional Diagram of the Stand
- Appendix B. The Dimensional Diagram of the Camera
- Appendix C. Ping IP Address
- Appendix D. Configuring Port Forwarding Manually
- Appendix E. Waterproofing the Cable Connections
- Appendix F. Joystick Compatibility
- Appendix G. Connecting Audio Devices
- Appendix H. Connecting Digital Input/ Digital Output Devices
- Appendix I. How to Replace the Fuse
- Appendix J. Troubleshooting & Frequently Asked Questions
2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
73
camera is found. By default, the serial number of the camera is used as a friendly name;
however, the user can modify the name according to the project needs.
After changing any of the items above, press Apply to save the changes. The Reset button
undoes the changes that had just been made but not Applied yet.
Most of the Windows-based computers have the capability to discover the devices that
support UPnP
TM
. Below is the example of Windows 7: By clicking on the Network icon of
Windows 7, the PC will discover the cameras instantly.
Bonjour
The Bonjour section provides the option to enable or disable the ability of the camera to be
discovered by the other network devices using Bonjour protocol, developed by Apple Inc.
Both Bonjour and UPnP serve the similar purpose – to discover devices conveniently.
Similarly to UPnP, the human readable Friendly Name can be defined by the user. That
name will be displayed when the camera is found in the network. By default, the Friendly
Name is the serial number of the camera; however, the user can modify the name according
to the project needs.
After changing any of the items above, press Apply to save the changes. The Reset button
undoes the changes that had just been made but not Applied yet.
ONVIF
The camera with the given firmware is ONVIF 2.2 compliant. By default, the ONVIF function
is enabled.