User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- 2.1 Physical Descriptions
- 2.2 Hardware Installation
- 2.3 Initial Utility Installation
- 2.4 Using UPnP of Windows XP or 7
- 2.5 Setting Up ActiveX for the Camera
- Chapter 3. Web-based Management
- Appendix A. The Dimensional Diagram of the Stand
- Appendix B. The Dimensional Diagram of the Camera
- Appendix C. Ping IP Address
- Appendix D. Configuring Port Forwarding Manually
- Appendix E. Waterproofing the Cable Connections
- Appendix F. Joystick Compatibility
- Appendix G. Connecting Audio Devices
- Appendix H. Connecting Digital Input/ Digital Output Devices
- Appendix I. How to Replace the Fuse
- Appendix J. Troubleshooting & Frequently Asked Questions
2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
17
Chapter 2. Hardware Interface
2.1 Physical Descriptions
2.1.1 Identification of ICA-E6260 Rear Panel and Connectors
Items
Description
Memory Card Slot
Supports microSDHC card.
Inserts a memory card (not included) into this slot for local recording
purposes.
Reset Button
Use the Reset Button to restore the camera to factory default
settings. To do the reset, press and hold the Reset button for at least
5 seconds or until the Power LED lights off. The camera will reboot
and restore to factory default settings.
Power LED
The Power LED lights up when the camera is connected to the power
source.
Reset Button
Micro SD Card
Slot
Power LED