User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- 2.1 Physical Descriptions
- 2.2 Hardware Installation
- 2.3 Initial Utility Installation
- 2.4 Using UPnP of Windows XP or 7
- 2.5 Setting Up ActiveX for the Camera
- Chapter 3. Web-based Management
- Appendix A. The Dimensional Diagram of the Stand
- Appendix B. The Dimensional Diagram of the Camera
- Appendix C. Ping IP Address
- Appendix D. Configuring Port Forwarding Manually
- Appendix E. Waterproofing the Cable Connections
- Appendix F. Joystick Compatibility
- Appendix G. Connecting Audio Devices
- Appendix H. Connecting Digital Input/ Digital Output Devices
- Appendix I. How to Replace the Fuse
- Appendix J. Troubleshooting & Frequently Asked Questions
2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
16
Alarm Triggering
Video motion detection (10 regions), tamper, shock
detection, sound detection and external input
Alarm Events
Notify control center; go to PTZ preset point or preset
tour, change camera settings; command other devices;
e-mail notification with snapshots; save video or snapshot
to local storage; upload video and snapshot to FTP
server; activate external device through digital output
General
Power Supply
High PoE (IEEE 802.3at)
AC 24V ± 10%
Power Consumption
PoE: 29.4W (with heater)
AC 24V: 68W (with heater)
Housing
IK-09 and IP 67 rating
Operating Temperature
-40 ~ 55 degrees C (within 30mins)
Operating Humidity
10 ~ 85% (non-condensing)
Weight
2500g
Dimensions (Φ x H)
200 x 276 mm
Emission
CE, FCC
Connectors
10/100Mbps Ethernet, RJ45
Micro SDHC card slot (max. 32GB, class 10)
Terminal block for 4 alarm input and 2 output
External mic input
Audio out
AC power jack










