User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- 2.1 Physical Descriptions
- 2.2 Hardware Installation
- 2.3 Initial Utility Installation
- 2.4 Using UPnP of Windows XP or 7
- 2.5 Setting Up ActiveX for the Camera
- Chapter 3. Web-based Management
- Appendix A. The Dimensional Diagram of the Stand
- Appendix B. The Dimensional Diagram of the Camera
- Appendix C. Ping IP Address
- Appendix D. Configuring Port Forwarding Manually
- Appendix E. Waterproofing the Cable Connections
- Appendix F. Joystick Compatibility
- Appendix G. Connecting Audio Devices
- Appendix H. Connecting Digital Input/ Digital Output Devices
- Appendix I. How to Replace the Fuse
- Appendix J. Troubleshooting & Frequently Asked Questions
2 Mega-pixel PoE Plus Speed Dome IP Camera
ICA-E6260
146
Appendix G. Connecting Audio Devices
The camera comes with audio input and output jacks to connect a microphone or speaker to
the camera. The audio jacks are covered with a rubber protection. If using an audio input
device, such as a microphone with a built-in amplifier, connect the device to the Audio Input
jack (red) of the camera. If using an audio output device, such as a speaker, connect the
device to the Audio Output jack (green) jack of the camera.
If the camera is installed outdoors, be sure to wrap the audio connectors with waterproof
tape (can be purchased in local hardware stores).
1. Make sure that the connected audio input device has a built-in amplifier.
Connecting an ordinary microphone will dwarf sounds and will result in
inaudible recording.
2. If the audio connectors will not be used, leave the rubber caps on to avoid
dust from entering the connectors.