User's Manual

Figure 8-55
Step 2: Check "Enable" to enable intrusion detection.
Step 3: Select "Warn Region": The system supports setting up to 4 warn regions. After
selecting a warn region, you need to make the following settings. After setting, please click
"Save" below.
【
Drawing Area
】
Click “Drawing Area”, and move the mouse to the preview screen.
Click the left mouse button and draw the endpoint of the quadrilateral guard area, and
then click the preview interface to complete the area drawing.
【
Clear All
】
Used to delete the selected alert area.
【
Proportion
】
Indicates the proportion of personnel in the entire alert area. When the
proportion of personnel exceeds the set percentage, the system will generate an alarm.
The percentage is 50% by default. The larger the value is, the more people can be
accommodated in the alert area, and the less likely it is to trigger an alarm.
Step 4: When you need to set other Warn Region, repeat step 3 to complete the setup.
Step 5: Arming Schedule, as shown in Figure 8-56. You can view, edit, and delete the
arming time of the People gather detection. The default is to arm the alarm 24 hours a day.
You can adjust the arming time as follows:
- Method 1: Click the arming time period, manually fill in the start time and end time, set
up and click Save. If you need to delete the time period, click the "Delete" button and
then reset the time period.
- Method 2: Click the time of deployment, the time period will display two circles at both
ends. Move the mouse to the circle to show the left and right direction of the