User's Manual

"Save" below.
【
Drawing Area
】
Click “Drawing Area” and move the mouse to the preview screen.
Click the left mouse button and draw the endpoint of the quadrilateral guard area, and
then click the preview interface to complete the area drawing.
【
Clear All
】
Used to delete the selected alert area.
【
Time threshold(min)
】
Indicates that the target generates an alarm after continuous
movement in the detection area. The larger the time threshold is, the longer the target
continues to move in the detection area to trigger an alarm.
【
Sensitivity
】
Used to set the sensitivity of detected area intrusion. The default is 50.
Drag the progress bar or enter the value directly in the value box to modify the sensitivity.
The greater the sensitivity is, the easier it is to trigger an alarm.
Step 4: When you need to set other Warn Region, repeat step 3 to complete the setup.
Step 5: Arming Schedule, as shown in Figure 8-54. You can view, edit, and delete the
arming time of the Loitering detection. The default is to arm the alarm 24 hours a day. You
can adjust the arming time as follows:
- Method 1: Click the arming time period, manually fill in the start time and end time, set
up and click Save. If you need to delete the time period, click the "Delete" button and
then reset the time period.
- Method 2: Click the time of deployment. The time period will display two circles at
both ends. Move the mouse to the circle to show the left and right direction of the
adjustment arrow, and move the adjustment arrow to adjust the arming time.
- You can set up more than one time period for up to 8 time periods.
- After the day of deployment time is set, if the other time is also needed to set the
same arming time, click the right side of the timeline "
" copy button. In the "copy
to" interface, check the "Select All" or a day, then Click "OK".
- After setting, click "Save" to complete the setting of the arming time.