User's Manual

Step 6: Set the linkage method as needed.
【
Linkage Method
】
refers to the response made by the device when an alarm event
occurs. The linkage includes “General Linkage”, “Upload Via SMTP” and “Upload Via
FTP”.
○
4E A Loitering Detection
The loitering detection function is used to detect the target that stays within the set area
for more than the set time threshold, and then alarms according to the judgment result.
The specific steps are as follows:
Step 1: In the main interface click on the "Configuration → Events → Smart Event →
Loiter Detection" to enter the Loitering Detection settings interface, as shown in Figure
8-56.3
Figure 8-53
Step 2: Check "Enable" to enable intrusion detection.
Step 3: Select "Warn Region": The system supports setting up to 4 warn regions. After
selecting a warn region, you need to make the following settings. After setting, please click
 When the arming time is set, there can be no overlap between any two
time periods.