User's Manual

Figure 8-38
【
Enable
】
Turn on / off device video tampering alarm.
Area Settings: Select the area to set the video tampering sensitivity.
【
Drawing Area
】
Move the mouse to the preview screen and click the left mouse button
to select the range of motion detection and release the left mouse button. Click “Stop
Drawing” to complete the alarm area selection.
【
Clear All
】
Clearing all the video tempering areas that were selected.
【
Sensitivity
】
The default is 0. The range of 0-2 is manually selectable. The greater the
value is, the more sensitive the equipment alarm will be.
Arming Schedule
：
As shown in Figure 8-39, you can view, edit, and delete the arming
time of the video tampering. The default is to arm the alarm 24 hours a day. You can
adjust the arming time as follows:
- Method 1: Click the arming time period and manually fill in the start time and end time,
set up and click Save. If you need to delete the time period, click the "Delete" button
and then reset the time period.
- Method 2: Click the arming time period; two arrows will be displayed at both ends of
the time period. Move the adjustment arrow left or right to adjust the arming time.
- You can set up more than one time period for up to 8 time periods.