User's Manual

Figure 8-27
【
Day and night switch
】
By default, the light mode is automatic where sensitivity is 3,
and filter time is 3 seconds. When the light mode is manual, light brightness is 100, as
shown in Figure 8-28
○
1 . When it is "Automatic", the device will turn on the light according
to the actual environment. The user can switch the mode to "Daytime ", "Night" and "Time"
according to the actual environment of the site, and switch the sensitivity and filter time of
the device according to the mode you want.
Figure 8-28
○
1E
- When the mode is "Time", you can set the Dawn time and the Dark time (the start and
end time) and the light brightness, as shown in Figure 8-28
A
○
2E A:
Figure 8-28 A
○
2E
- When the mode is "Daytime", the device monitor video is lit to have the daytime effect.
- When the mode is "Night", the device monitor video is added to the night effect.
Filtering time: It is used to prevent the ambient light from getting better and the light is
frequently turned on and off, and the filtering time is set. During this time period, the
camera is not disturbed by ambient light.