User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Device Time Setting
- Adjust
- Manual Setting:
- Click this option to set time and date manually.
- Synchronize with NTP:
- Click this option if you want to synchronize the device’s date and time with those of time server called NTP server (Network Time Protocol).
- Time Zone
- Set the time difference from Greenwich Mean Time in the area where the device is installed.
- Timing Address
- Enter the NTP server IP address.
- Appendix A: Ping IP Address
- Appendix B: Bandwidth and Video Size Estimation
- Appendix C: DDNS Application
- Appendix D: Configuring Port Forwarding Manually
- Appendix E: Power Line Frequency
- Appendix F: Troubleshooting & Frequently Asked Questions
1080p IR Bullet PoE IP Camera
ICA-4460V
- 49 -
Alarm Enable To enable or disable the Alarm service here.
Sensitivity
Define the sensitivity value of motion detection. The higher the
value is, the more sensitivity it will be.
Alarm Duration (S)
For example, if you select "10 sec" here, once the motion is
detected and action is triggered, it cannot be triggered again
within 10 seconds.
Motion Detection Area
Click “ Motion detection area” to select the motion area
Select one region on the image, click “Set” to save this setup.
Click “Query” to check the selected masking region.
Click “Delete All” to delete all Masking regions.
Or select one region, and click “Delete Selected”.
Weekly
After completing the schedule setup, the camera data will be
triggered according to the schedule setup.
Alarm Capture
Send JPG file to FTP server triggered by motion.
Sending Email
Send message to e-mail server triggered by motion.