User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Device Time Setting
- Adjust
- Manual Setting:
- Click this option to set time and date manually.
- Synchronize with NTP:
- Click this option if you want to synchronize the device’s date and time with those of time server called NTP server (Network Time Protocol).
- Time Zone
- Set the time difference from Greenwich Mean Time in the area where the device is installed.
- Timing Address
- Enter the NTP server IP address.
- Appendix A: Ping IP Address
- Appendix B: Bandwidth and Video Size Estimation
- Appendix C: DDNS Application
- Appendix D: Configuring Port Forwarding Manually
- Appendix E: Power Line Frequency
- Appendix F: Troubleshooting & Frequently Asked Questions
1080p IR Bullet PoE IP Camera
ICA-4460V
- 47 -
Status
When the camera is connected to cloud server, the status will
show “OnLine”.
When the camera is disconnected from cloud server, the status
will show “OffLine”.
User can use mobile app to watch video only when the status is “OnLine”.
If the status is “OffLine”, please check the following:
Please set the camera’s TCP/IP setting to make it connect to internet.
Is there a firewall or DMZ server in your network? If yes, please set it as
disable.
Does the camera get internet access via router or other devices?
If yes,
please set the UPnP of router as enable.
3.7 Advanced Tool
Refer to this menu to perform the principal settings of the camera.
3.7.1 Time Setting
User can set up the time setting of Internet camera. Synchronize it with PC or remote NTP
server. Also, you may select the correct time zone of your country.
Device Time
Displays the date and time of the device.
Synchronize with PC: