User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Device Time Setting
- Adjust
- Manual Setting:
- Click this option to set time and date manually.
- Synchronize with NTP:
- Click this option if you want to synchronize the device’s date and time with those of time server called NTP server (Network Time Protocol).
- Time Zone
- Set the time difference from Greenwich Mean Time in the area where the device is installed.
- Timing Address
- Enter the NTP server IP address.
- Appendix A: Ping IP Address
- Appendix B: Bandwidth and Video Size Estimation
- Appendix C: DDNS Application
- Appendix D: Configuring Port Forwarding Manually
- Appendix E: Power Line Frequency
- Appendix F: Troubleshooting & Frequently Asked Questions
1080p IR Bullet PoE IP Camera
ICA-4460V
- 45 -
3.5.4 FTP Setting
You may set up FTP parameters for further operation of Event Schedule. If users want to send
the alarm message to an FTP server, it will need to configure parameters here and also add at
least one event schedule to enable event triggering as SMTP.
FTP enable
To enable or disable the FTP service here.
User Name
Type the user name for the FTP server.
Password
Type the password for the FTP server.
Server
Type the server name or the IP address of the FTP server.
3.5.5 E-mail Setting
User may set up SMTP mail parameters for further operation of Event Schedule. If users want
to send the alarm message out, it will need to configure parameters here and also add at least
one event schedule to enable event triggering.
SMTP Server
Type the SMTP server name or the IP address of the SMTP
server.