User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Device Time Setting
- Adjust
- Manual Setting:
- Click this option to set time and date manually.
- Synchronize with NTP:
- Click this option if you want to synchronize the device’s date and time with those of time server called NTP server (Network Time Protocol).
- Time Zone
- Set the time difference from Greenwich Mean Time in the area where the device is installed.
- Timing Address
- Enter the NTP server IP address.
- Appendix A: Ping IP Address
- Appendix B: Bandwidth and Video Size Estimation
- Appendix C: DDNS Application
- Appendix D: Configuring Port Forwarding Manually
- Appendix E: Power Line Frequency
- Appendix F: Troubleshooting & Frequently Asked Questions
1080p IR Bullet PoE IP Camera
ICA-4460V
- 42 -
3.5.2 Port Management
User may need to assign a different port to avoid conflict when setting up IP assignment.
TCP Port
Choose the TCP port.
HTTP Port
Set up web page connecting port and video transmitting port (Default:
80).
RTSP Port
Choose the RTSP port. The RTSP protocol allows a connecting client to
start a video stream. Enter the RTSP port number to use. The default
value is 554.
If you want log in the camera from internet, please set Port Forwarding of
your router for TCP port and TCP port+1,TCP port is used to login.
By default, the ports are 9060 and 9061.
3.5.3 PPPoE Setting
PPPoE stands for Point to Point Protocol over Ethernet
A standard that builds on Ethernet and Point-to-Point network protocol, it allows Internet
Camera to connect to Internet with xDSL or cable connection. It can dial up your ISP and get a
dynamic IP address. For more PPPoE and Internet configuration, please consult your ISP.
It can directly connect to the xDSL; however, it should be set up in a LAN environment to
program the PPPoE information first, and then connect to the xDSL modem. Power it on again
to enable the device to dial on to the ISP for connecting to the WAN through the xDSL modem.
The procedures are