User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Device Time Setting
- Adjust
- Manual Setting:
- Click this option to set time and date manually.
- Synchronize with NTP:
- Click this option if you want to synchronize the device’s date and time with those of time server called NTP server (Network Time Protocol).
- Time Zone
- Set the time difference from Greenwich Mean Time in the area where the device is installed.
- Timing Address
- Enter the NTP server IP address.
- Appendix A: Ping IP Address
- Appendix B: Bandwidth and Video Size Estimation
- Appendix C: DDNS Application
- Appendix D: Configuring Port Forwarding Manually
- Appendix E: Power Line Frequency
- Appendix F: Troubleshooting & Frequently Asked Questions
1080p IR Bullet PoE IP Camera
ICA-4460V
- 40 -
3.5.1 TCP/IP Setting
This section provides the menu of connecting the device through Ethernet cable.
Obtain an IP address
automatically
(DHCP)
Enable this checked box when a DHCP server is installed on the
network to issue IP address assignment. With this setting, the IP
address is assigned automatically. If this device cannot get an IP
address within limited tries, the device will assign a default IP
address for 192.168.0.20.
If you do not select “Obtain an IP address automatically”, then you
need to enter these network parameters by yourself.
IP Address
This address is a unique number that identifies a computer or device
on the WAN or LAN. These numbers are usually shown in groups
separated by periods, for example: 192.168.0.200.
The default IP is 192.168.0.20 if there is no DHCP server in the
network.
Subnet Mask
Subnets allow network traffic between hosts to be separated based