User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Device Time Setting
- Adjust
- Manual Setting:
- Click this option to set time and date manually.
- Synchronize with NTP:
- Click this option if you want to synchronize the device’s date and time with those of time server called NTP server (Network Time Protocol).
- Time Zone
- Set the time difference from Greenwich Mean Time in the area where the device is installed.
- Timing Address
- Enter the NTP server IP address.
- Appendix A: Ping IP Address
- Appendix B: Bandwidth and Video Size Estimation
- Appendix C: DDNS Application
- Appendix D: Configuring Port Forwarding Manually
- Appendix E: Power Line Frequency
- Appendix F: Troubleshooting & Frequently Asked Questions
1080p IR Bullet PoE IP Camera
ICA-4460V
- 36 -
Video Format
Video codec of the selected profile.
Resolution
Main stream
2592x1520, 2304x1296, 1920x1080, 1280x1024, 1280x960,
1280x720, 704x576, 640x480
Sub stream
704x576, 640x480, 352x288, 320x240, 176x144
Frame Rate
Defines the targeted frame rate of this profile. For example, set
the frame rate to 30 fps, then the image will be updated for 30
frames per second. User can set the desired maximum frame
rate versus video quality under the limited bandwidth.
Bit Rate Control
Defines the rate control method of this profile. There are two
options: Constant Bit Rate (CBR) and Variable Bit Rate (VBR).
For CBR, the video bit rate is between low and high bandwidth
based on different resolutions. User can set the desired bit rate
to match the limitation of bandwidth.
For VBR, user should choose the quality level to set the video
quality rather than bit rate. The quality level is between 1 and
100. The higher value can reach the better quality but of
course will consume higher bandwidth.
Video Bitrate
Defines the limited bandwidth of this profile