User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Device Time Setting
- Adjust
- Manual Setting:
- Click this option to set time and date manually.
- Synchronize with NTP:
- Click this option if you want to synchronize the device’s date and time with those of time server called NTP server (Network Time Protocol).
- Time Zone
- Set the time difference from Greenwich Mean Time in the area where the device is installed.
- Timing Address
- Enter the NTP server IP address.
- Appendix A: Ping IP Address
- Appendix B: Bandwidth and Video Size Estimation
- Appendix C: DDNS Application
- Appendix D: Configuring Port Forwarding Manually
- Appendix E: Power Line Frequency
- Appendix F: Troubleshooting & Frequently Asked Questions
1080p IR Bullet PoE IP Camera
ICA-4460V
- 22 -
Please make sure the IP address of PC is in the same subnet as device’s IP
address.
2.3.4 Remote Update Function
Device Update: User can update firmware with the function. Please select a device
and click “Select File” to select the correct firmware, and then click ”Start Update” to
start to update the firmware.
1. Please make sure the firmware is correct. If the firmware is wrong, the device
might be damaged.
2. Do not do anything or power off device during the update process. It will damage
the device.
Import Config File: User may upgrade from the previous saved setting. Please
select a device and click “Select File” to select the correct setting file, and then
click ”Import” to start to upgrade setting.
Restore Factory: Delete all the settings in the device. Please select a device and
click “Restore Factory” to restore all settings to factory default setting.
Restore IP: Restore IP address to default IP address. The default IP address is
192.168.0.20. (If there is no DHCP server in the network) Please select a device
and click “Restore IP” to restore default IP address.
Synchro Time: Set device’s time to the same as PC’s. Please select a device and