User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Device Time Setting
- Adjust
- Manual Setting:
- Click this option to set time and date manually.
- Synchronize with NTP:
- Click this option if you want to synchronize the device’s date and time with those of time server called NTP server (Network Time Protocol).
- Time Zone
- Set the time difference from Greenwich Mean Time in the area where the device is installed.
- Timing Address
- Enter the NTP server IP address.
- Appendix A: Ping IP Address
- Appendix B: Bandwidth and Video Size Estimation
- Appendix C: DDNS Application
- Appendix D: Configuring Port Forwarding Manually
- Appendix E: Power Line Frequency
- Appendix F: Troubleshooting & Frequently Asked Questions
1080p IR Bullet PoE IP Camera
ICA-4460V
- 21 -
If user wants to set device as DHCP client, please refer to the following steps to set.
Step 1. Select an IP cam from the device list.
Step 2. Check the “Enable DHCP” box.
Step 3. Click “Generation”.
Step 4. Click “Modify” when you see the message and please click “Yes” to change the IP
address.