User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Physical Descriptions
- Chapter 3. Preparation
- Chapter 4. Web-based Management
- Chapter 5. Quick Connection to a Wireless Network
- Appendix A: DDNS Application
- Appendix B: FAQs
- Appendix C: Troubleshooting
- Appendix D: Glossary
- EC Declaration of Conformity
User Manual of IAP-1800AX & IAP-2400AX
- 45 -
If there are two LAN cards or above in the same administrator PC, choose a different
LAN card by using the “Select Adapter” tool.
3. Press the “Refresh” button for the currently connected devices in the discovery list as the screen
shows below:
Figure 3-6: PLANET Smart Discovery Utility Screen
1. This utility shows all necessary information from the devices, such as MAC address, device name,
firmware version, and device IP subnet address. It can also assign new password, IP subnet
address and description to the devices.
2. After setup is completed, press the “Update Device”, “Update Multi” or “Update All” button to
take effect. The functions of the 3 buttons above are shown below:
Update Device: use current setting on one single device.
Update Multi: use current setting on choose multi-devices.
Update All: use current setting on whole devices in the list.
The same functions mentioned above also can be found in “Option” tools bar.
3. To click the “Control Packet Force Broadcast” function, it allows you to assign a new setting
value to the device under a different IP subnet address.
4. Press the “Connect to Device” button and the Web login screen appears.
Press the “Exit” button to shut down the PLANET Smart Discovery Utility.