User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Physical Descriptions
- Chapter 3. Preparation
- Chapter 4. Web-based Management
- Chapter 5. Quick Connection to a Wireless Network
- Appendix A: DDNS Application
- Appendix B: FAQs
- Appendix C: Troubleshooting
- Appendix D: Glossary
- EC Declaration of Conformity
User Manual of IAP-1800AX & IAP-2400AX
- 40 -
Chapter 3. Preparation
Before getting into the device’s web UI, user has to check the network setting and configure PC’s IP
address.
3.1 System Requirements
Workstations running Windows XP/2003/2008/2012/Vista/7/8/10/11, MAC OS X or later, Linux,
UNIX, or other platforms are compatible with TCP/IP protocols.
Workstations are installed with Ethernet NIC (Network Interface Card)
Serial Port Connection (Terminal)
The above workstations come with COM port (DB9) or USB-to-RS232 converter.
The above workstations have been installed with terminal emulator, such as Tera
Term, PuTTY or Hyper Terminal included in Windows XP/2003.
Serial cable -- one end is attached to the RS232 serial port, while the other end to
the console port of the Managed Metro Switch.
Ethernet Port Connection
Network cables -- Use standard network (UTP) cables with RJ45 connectors.
The above PC is installed with Web browser.
It is recommended to use
Chrome 98.0.xxx or above to access the Industrial 802.11ax Wireless AP.
If
the Web interface of the
Industrial 802.11ax Wireless AP is not accessible, please turn off the anti-
virus
software or firewall
and then try it again.