Quick Guide

ManualsBrandsPLANET Technology ManualsAccess PointIndustrial 5GHz 802.11ax 2400Mbps Wireless Access Point with 5 10/100/1000T LAN Ports

- 9 -

- 10 -

- 11 -

- 12 - - 13 - - 14 -

3. The Industrial 802.11AX Wireless AP supports three operation

modes:

 Gateway Mode

 AP Mode (Default)

 Repeater Mode

Please follow the wizard to do the rst-time setup and select the mode

preferred.

Figure 4-3: Web Wizard Operation Mode of Industrial 802.11ax Wireless AP

4. After Web setup wizard is completed, enter the new username and

password. The main screen appears as Figure 4-4 shows.

Figure 4-4: Web Main Screen of Industrial 802.11ax Wireless AP

Now you can use the Web management interface to continue the

Industrial 802.11ax Wireless AP management.

Please refer to the user’s manual for more.

6. Central Management through

PLANET NMS

Follow the steps below to discover the managed AP through PLANET

NMS controller (NMS-500/NMS-1000V). Please ensure each managed

AP uses a dierent static IP in the same subnet before physically

connecting to the managed network.

Note

Please regularly check PLANET website for the latest

compatible list of the controller/managed APs in each

firmware version.

Step 1: Launch the Web browser (Google Chrome is recommended.)

and enter the default IP address https://192.168.1.100:8888

of the NMS controller. Then, enter the default username and

password “admin” to log on to the system.

* The secure login with SSL (HTTPS) prex is required.

Step 2: Go to the “Domain” page to discover and add the managed

AP to the device list. Then, you can go to the “AP Control->

AP Management” page to congure pre-dened proles to

the managed AP without logging on to the AP’s web page.

For further information about the conguration of Managed AP by using

PLANET Smart AP Control, refer to the conguration guide to the NMS

controller (NMS-500/NMS-1000V).

5.RecoveringBacktoDefaultConguration

IP address has been changed or admin password has

been forgotten –

To reset the IP address to the default IP address “192.168.1.253” or

reset the login password to default value, press the hardware reset

button on the front panel for about 10 seconds. After the device is

rebooted, you can log in the management Web interface within the

same subnet of 192.168.1.xxx.

Reset

USB

P1 Alarm

I/O

IAP-2400AX

5GHz

Wi-Fi

Reset Button

Figure 5-1: Industrial 802.11ax Wireless AP Reset Button

7. Customer Support

Thank you for purchasing PLANET products. You can browse our online

FAQ resource and User’s Manual on PLANET Web site rst to check if it

could solve your issue. If you need more support information, please

contact PLANET support team.

PLANET online FAQs:

https://www.planet.com.tw/en/support/faq

Support team mail address:

support@planet.com.tw

IAP-1800AX and IAP-2400AX User’s Manual:

https://www.planet.com.tw/en/support/downloads?&method=keyword&

keyword=IAP-1800AX&view=3#list

Contents are subject to revision without prior notice.

PLANET is a registered trademark of PLANET Technology Corp.

All other trademarks belong to their respective owners.