User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Connecting to the HDVR
- Chapter 4. Basic Operation
- Chapter 5. Main Menu
- Chapter 6. Web Remote Management
- Appendix A: Ping IP Address
- Appendix B: Planet DDNS Application
- Appendix C: Configuring Port Forwarding Manually
Hybrid Digital Video Recorder
H.265 HDVR series
26
4.3.4 PTZ Control
PTZ control is a little different between analog mode and full digital mode.
1) Digital channel – the digital channel needs to link PTZ; the remote device should connect
with PTZ with protocol correctly set also.
2) Analog channel – Only when the device is connecting with PTZ and configuring protocol
correctly is OK.
Operation interface is shown below. The functions include PTZ direction control, speed, zoom,
focus, iris, preset, tour, auto pan and so on.
1. When Decoder A (B) line connects with HDVR A (B) line, the connection is right.
2. Click [main menu] > [system configuration] > [PTZ configuration] to set the PTZ
parameters.
3. The PTZ functions are decided by the PTZ protocols.
Picture 4.5 PTZ Setup
Speed
Set the PTZ rotation range. Default range: 1 ~ 8.
Zoom
Click the / button to adjust the focal length of the
camera.
Focus
Click the / button to adjust the focus of the camera.
Iris
Click the / button to adjust the iris of the camera.
Preset
Click the / button to add or delete preset points.
Hide
The current interface will be temporarily hidden after clicking it.
Direction Control
Control the PTZ rotation. Control of 8 directions is supported.
(4 directions on Front panel is supported)
Page Switch
Switch between different pages.