Quick Guide

9
3. Installation
The HDP-5260PT is constructed of four parts as shown below. Prior to the
installation, the installer is required to remove the front panel of the HDP-5260PT
for wall mounting. Please follow the steps below for the installation.
Front Panel Main Part of Intercom Rain Shade Back Panel
Figure 1 Four Major Parts of HDP-5260PT
Step 1: Installation preparation
A. Check the following contents:
z Hex wrench x 1
z RJ45 plugs x 2 (1 spare)
z TA5 x 40mm screws x 5 (1 spare)
z 35mm screw anchors x 5 (1 spare)
z M4 x 16mm screw x 1 (spare)
z PM3 x 16mm screw x 1 (spare)
B. Tools that may be required:
z Hex wrench
z Phillips screwdriver (Ph2 or Ph3), hammer, RJ45 crimper
z Electric impact drill with an 8mm drill bit.