Quick Guide

12
Step 4: Back Panel Fixing and Cabling
TA5 x 40mm
Figure 6
Figure 7
15cm
A. Select the hole for cable supply; cable length of 15cm to 20cm is recommended.
B. With 4 TA5 x 40mm screws, tighten the back panel on the wall as shown in
Figure 6.
Note
The direction of the cable hole on the back panel should be
pointing down.
C. Connect the cables of RJ45, power, and electric-lock to the motherboard socket
as mentioned in connectors description (refer to Section 2).
D. Test whether there is electricity by doing the following:
Press the # button for 3 seconds to get the IP address of intercom by voice.
Input access password or press the indoor switch to check electric-lock installa-
tion.
Note
Do not proceed mounting until you have finished checking the elec-
tricity!