User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface
- Chapter 3. Web-based Management
- Chapter 4. Z-Wave Setting
- Appendix A: Configuring Z-Wave Device via Web
- Appendix B: Configuring Z-Wave via Smart Phone
- Appendix C: Configuring the Schedule of Z-Wave Device
- Appendix D: Troubleshooting & Frequently Asked Questions
Z-Wave Home Automation Control Gateway
HAC-1000
LED Color Description
PWR Green
Lights to indicate that the Switch has power.
LNK/ACT Green
Lights to indicate the port is successfully established.
Blinks to indicate that the switch is actively sending or
receiving data over that port.
Interface Description
Reset
This button is hidden in the pinhole. This button is used to restore all the
factory default settings. Please hold the reset button for about 10 seconds
to load default.
2.2 Hardware Installation
A. Wall-mount Installation
To install the PoE Ethernet Switch on the wall, simply follow the following steps:
Step 1: There are 4 holes with 8mm diameter on the wall; the distance between the 2 holes is
133mm and the line through them must be kept horizontal.
Step 2:
Install a conductor pipe inside the board hole and flush the edge of the conductor pipe
with the wall surface.
Step 3: Screw the bolts into the conductor pipe. The HAC-1000 is between bolts and conductor
pipe, as shown below.
- 10 -