User Manual

15
3.2 Rack Mounting
To install the 802.3at PoE+ Switch in a 19-inch standard rack, follow the
instructions described below.
Step1:
Place your 802.3at PoE+ Switch on a hard at surface, with the front
panel positioned towards your front side.
Step2:
Attach a rack-mount bracket to each side of the 802.3at PoE+ Switch
with supplied screws attached to the package. Figure 3-2 shows how to
attach brackets to one side of the 802.3at PoE+ Switch.
Figure 3-2: Attaching the Brackets to the 802.3at PoE+ Switch.
You must use the screws supplied with the mounting brackets.
Damage caused to the parts by using incorrect screws would inval-
idate the warranty.
Step3:
Secure the brackets tightly.
Step4: Follow the same steps to attach the second bracket to the opposite side.
Step5: After the brackets are attached to the 802.3at PoE+ Switch, use suitable
screws to securely attach the brackets to the rack, as shown in Figure
3-3.
Figure 3-3: Mounting the 802.3at PoE+ Switch in a Rack