GS-5220-Series (V4) User Manual

User’s Manual of GS-5220 PoE Series Managed Switch
382
Default setting is "Disable".
In the Extend operation mode, the PoE port operates at 10Mbps duplex
operation but can support PoE power output over a distance of up to 160 meters
overcoming the 100m limit on Ethernet UTP cable.
• Priority
The Priority represents PoE ports priority. There are three levels of power priority
named Low, High and Critical.
The priority is used in case the total power consumption is over the total power
budget. In this case, the port with the lowest priority will be turned off, and power
for the port of higher priority will be offered.
• Power Allocation
The Powe Allocation column shows per port maximum value of PoE power.
Once power overload is detected, the port will automatically shut down and
continue to be in detection mode until Pad’s power consumption is lower than
the power limit value.
 95W UPOE/PoH
 90W 802.3bt PoE++
 60W Force Power
 36W End-span PoE
 36W Mid-span PoE
PoE Extended Function
In the “Extended” operation mode, the GS-5220 series operates on a per-port basis at 10Mbps duplex operation but can
support PoE power output over a distance of up to 200 meters overcoming the 100 meters limit on Ethernet UTP cable.