User Guide

Command Guide of GS-5220-16S8C and GS-5220-16S8CR
Both (Tx +Rx)
Usage Guide:
To configure LLDP Tx only mode for specific interface
Example:
To configure LLDP Tx only mode for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp transmit
4.2.65.60 loop-protect
Command:
loop-protect
loop-protect Loop protection configuration
Default:
Enabled
Usage Guide:
To enable loop-protect for specific interface
Example:
To enable loop-protect for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # loop-protect
4.2.65.61 loop-protect action
Command:
loop-protect action [log] [shutdown]
loop-protect Loop protection configuration
action Action if loop detected
log Generate log
shutdown Shutdown port
Default:
-125
-