User Guide

Table Of Contents
Command Guide of GS-5220-16S8C and GS-5220-16S8CR
4.2.65.30 gvrp leave-request vlan(GG)
Command:
gvrp leave-request vlan <vlan_list>
gvrp Enable GVRP on port(s)
leave-request Emit a Leave-Request for test purpose
Default:
N/A
Usage Guide:
To send GVRP Leave-Request to specific interface
Example:
To send GVRP Leave-Request(VLAN 1) to GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # gvrp leave-request vlan 1
4.2.65.31 ip arp inspection check-vlan
Command:
ip arp inspection check-vlan
arp Address Resolution Protocol
inspection ARP inspection
check-vlan ARP inspection VLAN mode config
Default:
Disable
Usage Guide:
To configure Check-VLAN mode into ARP inspection for specific interface
Example:
To configure Check-VLAN mode (Enabled) into ARP inspection for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
-1
10-