GS-4210-Series User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of GS-4210 Series
4.9.8.5 Rate Limit
The ARP Rate Limit Setting and Config screens in Figure 4-9-57 and Figure 4-9-58 appear.
Figure 4-9-57 ARP Rate Limit Setting Screenshot
The page includes the following fields:
Object Description
Port
Select port from this drop-down list
State
Set default or user-define
Rate Limit (pps)
Configure the rate limit for the port policer. The default value is "unlimited".
Buttons
: Click to apply changes.
Figure 4-9-58 ARP Rate Limit Setting Screenshot
The page includes the following fields:
Object Description
Port
The switch port number of the logical port
Rate Limit (pps)
Display the current rate limit
266