User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 Power over Ethernet (GS-4210-24P2S only)
- 4.15 RMON
- 4.16 Maintenance
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 6.1 User Mode Commands
- 6.2 Privileged Mode Commands
- 6.2.1 clear command
- 6.2.2 clock command
- 6.2.3 configure command
- 6.2.4 copy command
- 6.2.5 debug command
- 6.2.6 delete command
- 6.2.7 disable command
- 6.2.8 end command
- 6.2.9 exit command
- 6.2.10 no command
- 6.2.11 ping command
- 6.2.12 reboot command
- 6.2.13 renew command
- 6.2.14 restore-defaults command
- 6.2.15 save command
- 6.2.16 show command
- 6.2.17 ssl command
- 6.2.18 traceroute command
- 6.2.19 udld command
- 6.3 Global Config Mode Commands
- 6.3.1 aaa Command
- 6.3.2 boot Command
- 6.3.3 bridge Command
- 6.3.4 class-map Command
- 6.3.5 clock Command
- 6.3.6 dos Command
- 6.3.7 dot1x Command
- 6.3.8 do Command
- 6.3.9 enable Command
- 6.3.10 end Command
- 6.3.11 errdisable Command
- 6.3.12 exit Command
- 6.3.13 gvrp Command
- 6.3.14 hostname Command
- 6.3.15 interface Command
- 6.3.16 ip Command
- 6.3.17 ipv6 Command
- 6.3.18 jumbo-frame Command
- 6.3.19 l2 Command
- 6.3.20 lacp Command
- 6.3.21 lag Command
- 6.3.22 line Command
- 6.3.23 lldp Command
- 6.3.24 logging Command
- 6.3.25 mac Command
- 6.3.26 management-vlan Command
- 6.3.27 mirror Command
- 6.3.28 no Command
- 6.3.29 policy-map Command
- 6.3.30 port-security Command
- 6.3.31 qos Command
- 6.3.32 radius Command
- 6.3.33 rate-limit Command
- 6.3.34 rmon Command
- 6.3.35 Snmp Command
- 6.3.36 sntp Command
- 6.3.37 spanning-tree Command
- 6.3.38 storm-control Command
- 6.3.39 system Command
- 6.3.40 tacacs Command
- 6.3.41 udld Command
- 6.3.42 username Command
- 6.3.43 vlan Command
- 6.3.44 voice-vlan Command
- 7. SWITCH OPERATION
- 8. POWER OVER ETHERNET OVERVIEW
- 9. TROUBLESHOOTING
- APPENDIX A
- EC Declaration of Conformity
User’s Manual of GS-4210-16T2S_24T2S_24P2S
The Page includes the following fields:
Object Description
Select port for this drop do
wn list.
Port
T
he total number of events in which packets were dropped by the
probe due to lack of resources.
etherStatsDropEvents
T
he total number of octets of data (including those in bad packets)
received on the network.
etherStatsOctets
T
he total number of packets (including bad packets, broadcast
packets, and multicast packets) received.
etherStatsPkts
T
he total number of good packets received that were directed to the
broadcast address.
etherStatsBroadcastPkts
T
he total number of good packets received that were directed to a
multicast address.
etherStatsMulticastPkts
T
he total number of packets received that had a length (excluding
framing bits, but including FCS octets) of between 64 and 1518 octets.
etherStatsCRCAlignErrors
T
he total number of packets received that were less than 64 octets.
etherStatsUnderSizePkts
T
he total number of packets received that were longer than 1518
octets.
etherStatsOverSizePkts
T
he number of frames which size is less than 64 octets received with
invalid CRC.
etherStatsFragments
T
he number of frames which size is larger than 64 octets received with
invalid CRC.
etherStatsJabbers
T
he best estimate of the total number of collisions on this Ethernet
segment.
etherStatsCollisions
T
he total number of packets (including bad packets) received that were
64 octets in length.
etherStatsPkts64Octets
T
he total number of packets (including bad packets) received that were
between 65 to 127 octets in length.
etherStatsPkts65to127Octets
etherStatsPkts128to255Octets
The total number of packets (including bad packets) received that were
between 128 to 255 octets in length.
etherStatsPkts256to511Octets
The total number of packets (including bad packets) received that were
between 256 to 511 octets in length.
etherStatsPkts512to1023Octets
The total number of packets (including bad packets) received that were
between 512 to 1023 octets in length.
etherStatsPkts1024to1518Octets
The total number of packets (including bad packets) received that were
between 1024 to 1518 octets in length.
Button
: Click to clear the RMON statistics.
351