User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 Power over Ethernet
- 4.15 RMON
- 4.16 Maintenance
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 6.1 User Mode Commands
- 6.2 Privileged Mode Commands
- 6.2.1 clear command
- 6.2.2 clock command
- 6.2.3 configure command
- 6.2.4 copy command
- 6.2.5 debug command
- 6.2.6 delete command
- 6.2.7 disable command
- 6.2.8 end command
- 6.2.9 exit command
- 6.2.10 no command
- 6.2.11 ping command
- 6.2.12 reboot command
- 6.2.13 renew command
- 6.2.14 restore-defaults command
- 6.2.15 save command
- 6.2.16 show command
- 6.2.17 ssl command
- 6.2.18 traceroute command
- 6.2.19 udld command
- 6.3 Global Config Mode Commands
- 6.3.1 aaa Command
- 6.3.2 boot Command
- 6.3.3 bridge Command
- 6.3.4 class-map Command
- 6.3.5 clock Command
- 6.3.6 dos Command
- 6.3.7 dot1x Command
- 6.3.8 do Command
- 6.3.9 enable Command
- 6.3.10 end Command
- 6.3.11 errdisable Command
- 6.3.12 exit Command
- 6.3.13 gvrp Command
- 6.3.14 hostname Command
- 6.3.15 interface Command
- 6.3.16 ip Command
- 6.3.17 ipv6 Command
- 6.3.18 jumbo-frame Command
- 6.3.19 l2 Command
- 6.3.20 lacp Command
- 6.3.21 lag Command
- 6.3.22 line Command
- 6.3.23 lldp Command
- 6.3.24 logging Command
- 6.3.25 mac Command
- 6.3.26 management-VLAN Command
- 6.3.27 mirror Command
- 6.3.28 no Command
- 6.3.29 policy-map Command
- 6.3.30 port-security Command
- 6.3.31 qos Command
- 6.3.32 radius Command
- 6.3.33 rate-limit Command
- 6.3.34 rmon Command
- 6.3.35 Snmp Command
- 6.3.36 sntp Command
- 6.3.37 spanning-tree Command
- 6.3.38 storm-control Command
- 6.3.39 system Command
- 6.3.40 tacacs Command
- 6.3.41 udld Command
- 6.3.42 username Command
- 6.3.43 vlan Command
- 6.3.44 voice-vlan Command
- 7. SWITCH OPERATION
- 8. POWER OVER ETHERNET OVERVIEW
- 9. TROUBLESHOOTING
- APPENDIX A
- EC Declaration of Conformity
User’s Manual of GS-4210-24P2S
4.14.1 PoE Global Setting ..........................................................................................................................................284
4.14.2 PoE Port Setting ..............................................................................................................................................285
4.14.3 PoE Delay Setting ...........................................................................................................................................287
4.14.4 Power over Ethernet Powered Device .............................................................................................................289
4.15 RMON.......................................................................................................................................................290
4.15.1 RMON Statistics ..............................................................................................................................................290
4.15.2 RMON Event ...................................................................................................................................................292
4.15.3 RMON Event Log ............................................................................................................................................293
4.15.4 RMON Alarm ...................................................................................................................................................294
4.15.5 RMON History .................................................................................................................................................297
4.15.6 RMON History Log ..........................................................................................................................................299
4.16 Maintenance............................................................................................................................................300
4.16.1 Factory Default ................................................................................................................................................300
4.16.2 Reboot Switch .................................................................................................................................................301
4.16.3 Backup Manager .............................................................................................................................................301
4.16.4 Upgrade Manager............................................................................................................................................302
4.16.5 Configuation Manager .....................................................................................................................................303
4.16.6 Enable Password.............................................................................................................................................304
5. COMMAND LINE INTERFACE.......................................................................................... 306
5.1 Accessing the CLI ....................................................................................................................................306
Logon to the Console ..........................................................................................................................................306
Configure IP address...........................................................................................................................................307
5.2 Telnet Login ..............................................................................................................................................308
6. Command Line Mode....................................................................................................... 309
6.1 User Mode Commands ............................................................................................................................310
6.1.1 enable command ...............................................................................................................................................310
6.1.2 exit command .................................................................................................................................................... 311
6.1.3 ping command ................................................................................................................................................... 311
6.1.4 Show Command ................................................................................................................................................312
show arp..............................................................................................................................................................312
show history ........................................................................................................................................................312
show info .............................................................................................................................................................312
show ip ................................................................................................................................................................313
show privilege......................................................................................................................................................313
show version .......................................................................................................................................................313
6.1.5 traceroute command..........................................................................................................................................314
8