User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main Web Page
- 4.2 System
- 4.3 Port Management
- 4.4 Link Aggregation
- 4.5 VLAN
- 4.5.1 VLAN Overview
- 4.5.2 IEEE 802.1Q VLAN
- 4.5.3 Management VLAN
- 4.5.4 Create VLAN
- 4.5.5 Interface Settings
- 4.5.6 Port to VLAN
- 4.5.7 Port VLAN Membership
- 4.5.8 Protocol VLAN Group Setting
- 4.5.9 Protocol VLAN Port Setting
- 4.5.10 GVRP Setting
- 4.5.11 GVRP Port Setting
- 4.5.12 GVRP VLAN
- 4.5.13 GVRP Statistics
- 4.5.14 VLAN setting example:
- 4.6 Spanning Tree Protocol
- 4.7 Multicast
- 4.8 Quality of Service
- 4.9 Security
- 4.10 ACL
- 4.11 MAC Address Table
- 4.12 LLDP
- 4.13 Diagnostics
- 4.14 RMON
- 4.15 Power over Ethernet
- 4.16 Maintenance
- 5. SWITCH OPERATION
- 6. TROUBLESHOOTING
- APPENDIX A Switch's RJ45 Pin Assignments
User’s Manual of GS-4210 UPoE Series
2.2.3 Installing the SFP transceiver
The sections describe how to insert an SFP transceiver into an SFP slot. The SFP transceivers are hot-pluggable and
hot-swappable. You can plug in and out the transceiver to/from any SFP port without having to power down the Managed Switch,
as the Figure 2-1-7 shows.
Figure 2-1-7 Plug in the SFP transceiver
Approved PLANET SFP Transceivers
PLANET Managed Switch supports both single mode and multi-mode SFP transceivers. The following list of approved PLANET
SFP transceivers is correct at the time of publication:
Gigabit SFP Transceiver Modules
MGB-GT
SFP-Port 1000BASE-T Module
MGB-SX
SFP-Port 1000BASE-SX mini-GBIC module
MGB-LX
SFP-Port 1000BASE-LX mini-GBIC module
MGB-L50
SFP-Port 1000BASE-LX mini-GBIC module – 50km
MGB-L70
SFP-Port 1000BASE-LX mini-GBIC module – 70km
MGB-L120
SFP-Port 1000BASE-LX mini-GBIC module – 120km
MGB-LA10
SFP-Port 1000BASE-LX (WDM,TX:1310nm) – 10km
MGB-LA20
SFP-Port 1000BASE-LX (WDM,TX:1310nm) – 20km
MGB-LB20
SFP-Port 1000BASE-LX (WDM,TX:1550nm) – 20km
MGB-LA40
SFP-Port 1000BASE-LX (WDM,TX:1310nm) – 40km
MGB-LB40
SFP-Port 1000BASE-LX (WDM,TX:1550nm) – 40km
33